Lafvin elektronics starter kit

Very complete kit for electronics experiments for the Raspberry Pi, Raspberry Pi Pico or the Arduino. Comes in a sturdy storage box, including CD with instructions / lessons, code examples and wiring diagrams.

(The RaspberryStore is not responsible for the contents of the CD. Questions about the software should be directed to the manufacturer.)

Component list:

1 pcs GPIO Extension Board with Cables
1 pcs LCD1602 Module (with pin header)
1 pcs 8 * 8 Dot Matrix
1 pcs Stepper motor
1 pcs ULN2003 Stepper Motor Driver Board
1 pcs Servo Motor (SG90)
1 pcs Membrane Switch Module
1 pcs 9V Battery Connector with DC
1 pcs 3V Servo Motor (Soldered Wire)
1 pcs Fan Blade
1 pcs Joystick Module
1 pcs GY-521 Module
1 pcs Power Supply Module
1 pcs HC-SR501 PIR Motion Sensor
1 pcs Remote control
1 pcs 5 V Relay
1 pcs IR Receiver Module
1 pcs DHT11 Temperature and Humidity Module
1 pcs 830 Points breadboard (full-size)
1 pcs 65 Jumper Wire
20 pcs Dupont Wire
1 pcs 1 digit 7-segment Display
1 pcs 4 digit 7-segment Display
1 pcs Ultrasonic Sensor
20 pieces Resistor (220R)
10 pieces Resistor (1K)
10 pieces Resistor (10K)
5 pcs White LED
5 pcs Yellow LED
5 pcs Blue LED
5 pcs Green LED
5 pcs Red LED
1 pcs RGB LED
1 pcs Thermistor
2 pcs Photoresistor
1 pcs Potentiometer (10K)
1 pcs Active Buzzer
1 pcs Passive Buzzer
2 pcs Diode Rectifier (1N4007)
2 pcs NPN Transistor (PN2222)
1 pcs IC L293D
1 pcs IC 74HC595
1 pcs Thermistor
1 pcs Tilt Switch
5 pcs Small buttons